Warning

You are reading an old version of this documentation. If you want up-to-date information, please have a look at 2024.5 .

First startup

This chapter guides you from unpacking your elements to the start of your Asyfill.

Assembly of the Asyfill

  • Unpack the Asyfill actuator base and the container delivered in two packages as described in unpacking instructions

  • Fix the container on the actuator base with the 4 screws and washers included as described in assembling the container

Caution

Risk of pinching. Do not place your finger between the container and its actuator base. Do not touch the machine during a vibration.

Mounting and wiring of the Asyfill

  • Use the holes in the base plate to fix the Asyfill to a solid base with four M6 screws, refer to mounting the Asyfill for detailed information.

  • Connect the Asyfill to a 24 VDC power supply via the optional power cable.

  • Connect the Asyfill Input interface to one of the Asycube OUT port by using a I/O cable

../_images/quickstart_connect_asycube.png

Fig. 3 Connection with Asycube

Important

Check the correct polarity of your 24 VDC power plug before connection.

Note

Refer to section Electrical Interfaces to get more information.

Calibration of the Asyfill

Start using your Asyfill

  • The vibration amplitude of the Asyfill can now be tuned from Asycube Studio or Eye+ Studio. The execution of a vibration is triggered via the Asycube commands or directly by EYE+ depending on the system you are using. Refer to the appropriate user manual for more information.

Caution

Ear protection might be recommended, depending on the parts and vibration amplitude used in your application.