Mounting the Asyfill

To guarantee proper behavior of the Asyfill, a tight fastening to a solid base is necessary. Incorrect installation of the Asyfill could compromise performance. The four holes of the base plate can be used to fix the Asyfill mechanically with M6 screws. Refer to the section Overall dimensions to get the nominal dimensions of the fixation interface of the Asyfill.

Tip

Important

When using the Modular fixation kit for Asyfill M and L do not exceed a torque of 4 Nm when tightening the 4x M6 screws.

Integration with Asycube

Integration example is shown in Fig. 8 where the Asyfill is fixed on the same strong support as the Asycube. The integration of the Asycube must respect the guidelines described in Asycube Mechanical Integration.

../../_images/integration_with_asycube.png

Fig. 8 Integration of Asyfill and Asycube

Integration dos/don’ts

Good and bad integration examples are given in Fig. 9 to Fig. 11. In general, we recommend mounting the Asyfill directly on the machine frame.

../../_images/integration_asyfill_correct.png

Fig. 9 Correct integration of Asyfill

Important

Never attach Asyfill directly to vibration isolators, Asyfill already integrates vibration isolators in its housing. Using external vibration isolators would cause the inside of the Asyfill to vibrate more than the container itself and could irreversibly damage the electronic controller.

../../_images/integration_asyfill_damper.png

Fig. 10 Do not mount an Asyfill on vibration isolators

Important

Never attach Asyfill on a weak support or table.

../../_images/integration_asyfill_weak.png

Fig. 11 Do not mount an Asyfill on a week table